Loveliest Tree Card
Using the stamp sets Loveliest Tree and Textured Timbe, I create this card using the Triple Time stamping technique. Below is the instructions how to do the technique.
You also see different desigines on YouTube and Pinterest.
.png)
Card Measurement
1.First Layer card base any colour cardstock 14.8cm x 21cm scored at 10.5cm
2. Second Layer Basic White cardstock to measure 10 x 14.3cm
3. Third Layer as per card base as base card 8.5 x 12.8cm
4. Fourth Layer Basic White cardstock 8 x 12.3cm
5. Fifth Layer as per card base cardstock 6.5 x 10.8cm*
6. Sixth and last layer Basic White cardstock 6 x 10.3cm
Instructions:
Use low stick tape ( to temporarily tack down the two smallest layers of the Whisper White cardstock on top of the largest Whisper White cardstock, making sure that they are evenly spaced
Use a clear block for easier stamping. using a stamp of your choice, randomly stamp on top of all three layers while they are stuck together, as shown in the photo.
Don't worry about any white gaps you may see now where the images didn't stamp up to the edge. You won't see these at all later on. But to reduce the white gaps and to get a good image rock the clear block slightly when stamping around the edges of the layers.
Gently pull apart the stamped Whisper White cardstock.
1.Layer the 8.5.x 12.8cm coloured cardstock onto the 10.cm x 14.3cm stamped Basic White cardstock.
2. Layer the 12.3cm x 8cm stamped Basic White cardstock onto the 12.8cm x 8.5cm
colourd cardstock,
3. Layer the 12.3cm x 8cm stamped basic White cardstock onto 12.8cm x 8.5cm coloured
cardstock,
4. Layer the coloured 10.8cm x 6.5cm cardstock onto the 12.8cm x 8.5cm Basic White
cardstock,
5. Place the last layer on to the 10.8cm x 6.5cm coloured cardstock
Then attach the layered pieces to the card base.
I will be back soon with another card and instustions.
Colleen Johnson
Independent Stampin' Up! Demonstrator
No comments:
Post a Comment